Latest News

Sales in 2008: -

Currently being updated.

New Products......

The CBC-M Integrator is now available with a new Data Logging facility. A comprehensive set of production and management data can be "printed / written" to a Flash Drive / Memory Stick and this can then be transferred to any P.C. running Microsoft Excel.

No special software, licence or modification is required by the receiving P.C.. The Flash Drive will automatically present an Excel file of the recorded data and this can then be analysed using the powerful and familiar features of the Excel program.

Information such as Production Efficiency, Performance Graphs, Historical Performance Records etc. can all be produced and if required integrated into reports that can be forwarded to head offices etc. for further evaluation.

Unlike some other data logging systems this low cost feature is very easy to use as it based on a program (Microsoft Excel) used by most managers around the world.

The 5th Generation CBC Integrator.

The new integrator will not replace the highly successful CBC-M (4th Generation) model. It is being introduced to provide an extended range of "high end" features that have been incorporated following customer feedback.

As in all previous models it will use the same customer interface so that existing customers will not have to learn any new operating proceedures.

The new system will have some powerful and interesting new features but will be still remain competitive in price.

New Low Cost Tilt Switch Relay.

The new tilt switch relay has been introduced to provide a low cost control for our range of tilt switches probes. The board will operate on 240/110 vac and 24 vdc. and a safe12vdc signal voltage is supplied to the tilt switch probe. Red and Green LED indicators show the current probe status and a variable time delay adjustment is provided to prevent false alarms. Relay contact outputs are available for switching control circuits.

New Speed Monitoring / Motion Sensing Systems.

Two new control systems are available in addition to the existing 712-S control board.
The 712-S continues to provide the most sophisticated features for single channel applications. (See full details on Product page)

The new models are available in six channel (Model 6CSM) and two channel (Model 2 CSM) versions.

These control systems are designed pricipally for use with our speed sensor range, but can be used with proximity sensors etc.

The model shown here is a 24/12 vdc 6CSM. Up to six speed inputs can be accepted and monitored. When a signal is received from the speed sensor the channel remains in "active" condition. When the signal is not received (ie. for example the belt/shaft has stopped turning) the channel will transfer to "alarm" condition after a pre-set time period. (normally 3 seconds but can be changed to the customer requirements). A relay contact is provided for each channel. The unit can be programmed (by moving the link pins) so that each channel works independently - or - any one channel failing can close all six channels. The control board is available for panel mounting or can be supplied in an IP65 enclosure complete with LED channel status indicators.

Conveyor Safety Products: - Pull Wire Switches - Belt Misalignment Switches - Lever Limit Switches

The full range of D&K conveyor safety products are now available from stock. These high quality units are available in impact resistant, thick walled, glass fibre re-inforced polyester or cast iron.
Up to 4 contacts are available (4 NC + 4 NO). The units offer IP66 protection.
The models shown here are all of the "latching" variety but they can also be supplied without this feature.
All bearings, rollers, fastenings etc. are manufactured in Stainless Steel to ensure an extended, reliable working life in the most arduous environments.
Models are available for EX environments according to the ATEX-guideline for use in Zone 21 and 1.